In the process of wallpaper paving, many people believe weighed against parquet wallpaper, plain wallpaper is simpler and far more convenient to use without mosaic. As it happens that basic wallpapers 
are basic and easy to lay out because they have no patterns, however the relative stitching requirements are more stringent. Plain colors, especially darker plain shades, are relatively more prone to seam complications. If the simple wallpaper includes a seam phenomenon, what’s the reason behind judging the seam? After that take the correct approach.
1. There exists a gap
If the seam sometimes appears at 1.5m on the front side, there is absolutely no color difference in the wallpaper. Is it serious to deal with the seams during construction? Most of the causes of the seams are due to construction problems.
Approach
1. If the wallpaper is certainly a rubberized wallpaper, you can wet the seam with a wet towel, open the wallpaper glue, gently pry open the wallpaper, and use the wallpaper softener to soften the wallpaper to extend the wallpaper and repair the seams.
2. If it’s a pure paper wallpaper or a non-woven wallpaper, there is nearly no stretchability, so it can’t be repaired by the above technique. The base could be shaded with a paint-coated seam that’s very similar in color to the wallpaper.
2.Yin and Yang
When there is obviously zero overall feeling between your wallpaper strips at 1.5m on the front aspect, the seams of the wallpapers are handled well in close distances, and there is absolutely no apparent seam phenomenon. It appears that the wallpaper looks like a color difference, and the colour difference at the seam is definitely in accordance with the apparent law of deep-shallow-deep-light or shallow-deep-shallow-deep, which might be Silk Wallcoverings caused by the yin and yang.
Discover the label of the wallpaper and see if there is an alternate label on the top and bottom level of the label – ↑↓.
Approach
1. If there is, it requires to end up being alternately pasted according to the logo design, ie: shallow-shallow-deep-deep relative to prevent the phenomenon of yin and yang.
2. When there is no logo design, it really is caused by the product quality issue of the wallpaper. There is no solution in fact it is required to respond to the wallpaper sales office.
3 white side
If the bottom paper is available to be slightly longer when the dark wallpaper is constructed, you will have a white edge at the seam following the construction. The gap is definitely clearly visible far away of just one 1.5 m from the front of the wall.
Approach
1. Because the wallpaper is not constructed with simple wallpaper, the seam could be treated by the technique of edging.
2. If the wallpaper has been built, it can be used in the same color as the wallpaper. (That is a versatile method)
4 overflow glue
The plain wallpaper isn’t easy to erase after filled with glue, and there are residual rubberized marks after rubbing.
Precautions
1. When constructing, make sure to check whether there is an “up and down alternate” construction mark on the wallpaper label. If there is this logo design, the wallpaper ought to be positively and negatively submitted. When there is still a negative and positive surface area phenomenon, you can try normal stickers again.
2, plain color non-woven wallpaper construction should try to avoid spilling glue, avoid wiping, after the wiping strength is normally large, it could leave traces. If you are unfortunate enough to spill the glue, you should wipe the spilled glue in the smallest range, and the softer color of the plain wallpaper should be gentle.
3, rubber surface simple wallpaper, the 1st wallpaper paste for around 30 minutes must pay attention to check if the seams of the wallpaper have got offset printing. If there is offset printing, it implies that the rubberized wallpaper can’t overflow, and the glue will keep traces.