How to strip old wallpaper? Give you a few small tricks!

Many owners have no idea how to deal with the outdated wallpaper on the wall when replacing the wallpaper; if you continue to paste new wallpaper on the outdated wallpaper, the aged and outdated wallpapers may fall off the wall together because of the wetness of the adhesive. The simplest way to do that is usually to strip the older wallpaper to ensure that the wall structure covering sticks to the wall structure more firmly.
Here are some ways to uncover old wallpapers.
Peelable wallpaper
1. Pick an inconspicuous corner near the top of the wall and utilize the tip of the utility knife to get the wallpaper.
2. Try to be near to the wall, pinch the part of the wallpaper, and try to remove it from the wall. Strip the wallpaper in your direction, making it easier to remove the wallpaper. If it’s a peelable wallpaper, the wallpaper will detach from the wall so long as you are strenuous and moderate.
Cut and infiltrate
1. Use a utility knife, razor blade or wallpaper scraper to cut the older wallpaper horizontally, each slit is about 20 or 25 cm apart.
2. Apply water or wallpaper remover and wait a couple of minutes for the wallpaper to completely saturate.
3. Repeat the same procedure on another wallpaper strip, then go back to the first strip and re-wet it throughout with the formulation.
4. Begin stripping the wallpaper with a multi-purpose edging knife with a 8.9 cm wide, movable blade. Starting from a lower horizontal wallet, the blade is certainly placed under its upper edge and the blade is at an angle of 30 degrees to the horizontal, and the sliding blade scrapes the wetted wallpaper. A wallpaper that is the same width as the squeegee will fall off the blade and roll onto the squeegee as the blade pushes down.
5. Continue steadily to push down before wallpaper can no longer be taken off. If the scraped wallpaper tape breaks, re-infiltrate this area and start to scrape another tape.
Steam method
It is not easy to peel off aged wallpaper. You can rent a steam engine, but you still need to use a wide-blade putty knife to scrape the majority of the wallpaper.
1. Following the water is hot, press the steam plate on the wall structure before wallpaper on the edge of the steam plate turns into dark due to moisture. Focus on a strip of paper and steadily peel from the lime the wallpaper throughout.
2. After steaming half of the paper strip, make use of a nail or a utility knife to draw up the corner of the very best of the wallpaper and tear off the wallpaper. If the wallpaper can’t be removed, it can be scraped off with a wall scraper. You may want to steam the same region twice or 3 x to loosen the adhesive for the much longer a few months of the wallpaper.
For waterproof Modern Style Wallpaper coatings, cleaning the wall structure paper glue with alcohol does not cause much harm to the wall. Instead, the volatilization of alcoholic beverages can minimize the damage to the wall structure. But one thing to notice is that the focus of alcohol shouldn’t be too high. Otherwise, the volatility can be too large, and it is simple to make the white wall structure turn yellow or dark. This is a very bad phenomenon.
This technique uses physical friction. But because salt can be a white crystal, you don’t need to worry about the strange color that the friction brings to the wall structure. Along the way of rubbing, you may use white gauze or cloth that can keep salt, pack a small packet of salt, softly rub, gradually you will find that the glue still left on the wall paper is gradually disappearing, and then stuck in At the top of the fabric, you merely want to rub and prevent to eliminate the glue from the gauze. The next thing is never to be said.